Stud Welding Products, Inc. - FREE Quotes on Welding Studs, Welding Supplies, Welding Equipment for Stud Welding

Shear Connector Studs (3/4 & 7/8" Diameter)

For welding to fillet or heel of angle, consult your SWA representitive for the correct ferrule part number.

3/4" DIAMETER SHEAR CONNECTORS
Stud Specifications			Ferrule specifications
D	H	A	Type	No.	D	B	F	M
3/4	1 1/4	3/8	Flat Surface	FF-075	1.215	1.030	.469	.656
			Weld Through Deck	FW-075

Standard Length	Pounds M Pieces	Part Number
3 3/16	486	SCO750318
3 3/8	509	SCO750337
3 7/8	572	SCO750387
4 3/16	611	SCO750418
4 3/8	640	SCO750437
4 7/8	707	SCO750487
5 3/16	736	SCO750518
5 3/8	579	SCO750537
5 7/8	855	SCO750587
6 3/16	861	SCO750618
7 3/16	987	SCO750718
8 3/16	1112	SCO750818
9 3/16	1240	SCO750918
10 3/16	1373	SCO751018

7/8" DIAMETER SHEAR CONNECTORS
Stud Specifications			Ferrule specifications
D	H	A	Type	No.	D	B	F	M
7/8	1 3/8	3/8	Flat Surface	FF-087	1.408	1.210	.545	.732

Standard Length	Pounds M Pieces	Part Number
3 11/16	726	SCO870368
4 3/16	811	SCO870418
5 3/16	981	SCO870518
6 3/16	1153	SCO870618
7 3/16	1322	SCO870718
8 3/16	1473	SCO870818
9 3/16	1642	SCO870918
10 3/16	1800	SCO871018

All S.W.A shear connectors meet AWS specifications. Test reports available upon request.

SHEAR CONNECTOR STUDS are designed to effectively tie the concrete to steel beams and to resist shear loadings between the concrete slab and steel beam in composite construction. All orders for studs include required ferrules.

LENGTH: Length is before weld. Studs when welded to base metal will be approximately 3/16" shorter after weld and when welded through deck, 3/8" shorter after weld. Lengths for shear connector studs are generally set by governing specifications. Consult your SWA representitive for other lengths available for specific applications.

MATERIAL: Low carbon steel

STAINLESS STEELS: SC studs are also available in stainless steel

Mechanical Property Requirements

Type A¹

Type B²

Tensile Strength

55,000 psi min
(380 MPa)

60,000 psi min
(415 MPa)

Yield Strength
(0.2% offset)

50,000 psi min
(345 MPa)

Elongation
(% in 2-in.)

17% min

20% min

Reduction of Area

50% min

¹	Type A studs shall be general purpose of any type and size used for purposes other than shear transfer in composite beam design and construction.

²	Type B studs shall be studs that are heated, bent, or of other configuration in 1/2 in (12.7 mm), 5/8 in (15.9 mm), 3/4 in (19 mm), 7/8 in (22.2 mm), and 1 in (25.4 mm) diameter that are used as an essential component in composite beam design and construction.